Coloram ii power supply manual

Coloram II Power Supply Coloram and Power Supply System Level CXI Eclipse I Forerunner Color Changer Forerunner System Goboram II Motovator Linear mode channel chart Display control channel chart Setup mode channel chart Rotary mode channel chart Anita configuration file Download. All Coloram II Color Changers use gel strings which can vary in length. The color changers set the position of the gel string via the signal from the power supply in proportion to the DMX level. The color changers are powered by 24 volts DC which also comes from the power supply. The control signal and DC power are both supplied in. The Coloram II color changers are not intended for residential use. Introduction The Coloram II System is a scrolling color changer and power supply in a complete range of models offering ease of setup and use. COLORAM II is the latest and most advanced scroller from the company that invented them - and it shows.

This manual gives step-by-step instructions for preparation, setup and operation of The Coloram II Power Supply. There is a potential risk of fire, electric shock or injury to persons if the product is not used as instructed. The Eclipse Dowser uses a Coloram II Power Supply and Coloram II cable for control signal and 24VDC power. The dowser can be daisy chained with Coloram II Color Changers and Goborams. Vane position is determined by the DMX level (%) of the DMX channel to which the dowser is addressed. The dowser uses one DMX channel. The Coloram II System. The Coloram II System consists of one or more Color Changers or other components and a remote Power Supply. The DMX control signal from the lighting board is connected to the Power Supply and can continue on to more Coloram II Power Supplies or other DMXcontrolled devices.

Various length gel string scrolling capability ( colors) XLR 4-pin connectors supply power and control signal COLORAM POWER SUPPLY! The power/signal cable connector should be facing you, with the cable connecting it to output 12 on the. Power Supply (labeled AUTOLOAD). 2. Unscrew the two. This manual describes the RS®VTC () with firmware version FW If the product needs an external power supply, use the power supply that is.